Once DTR falls, disconnect and go to command mode This command may take time to implement, so the response from the modem may be delayed This command means Attention and is used to begin a session This causes the modem to close connections and go back to command mode If the modem fails to answer, the command has not been processed.Įscape Sequence. Note ♦ The modem must reply with either OK or READY to each command entered. Typical initialization strings used with an Siemens M20-type modem are shown below. To change the modem’s baud rate, type AT+IPR=19200&W the command '&W' burns the new baud rate into the modem's non-volatile memory. To test the connection, type AT if the connection is valid the modem will respond 'OK'. #Hyperterm application PcHyperterminal is now connected to your PC via Com 1 the ASCII settings now enable you to enter commands via the PC keyboard and see the replies from the modem within the Hyperterminal window. Select the options shown below, and then click OK. Open the modem’s Properties box by clicking on the Properties button, then open ASCII Setup. To enable your PC to communicate with the modem, set the COM port parameters to a BPS of either 9600 or 19200, Data bits=8, Parity=N, Stop bits=1, Flow control=None, and then click OK. The Port Settings box opens as shown below. Select a COM port for the modem, and then click OK. Note ♦ Hyperterminal generally starts by pointing to the internal modem, if one is installed on the PC.Įnter a name for the new connection and select an icon, and then click OK. The New Connection window opens as shown below. The program can generally be located by clicking the Start button in the lower left corner of your screen, then selecting Programs>Accessories>Communications>Hyperterminal. If the connection is direct, there are no further steps that you have to take.Open Hyperterminal. When HyperTerminal opens enter a name for the connection you want to establish by choosing the icon and then click on "OK." When the new dialog box appears type in a phone number and then choose the type of connection you want from the pull down menu. In the new Window click on "Windows Setup", choose "Communications" from the Components list, and then click on "Details." Choose the checkbox that is located next to "HyperTerminal" and then click "OK." If HyperTerminal is not installed on your computer you can define a connection for it by clicking on "Start" on your main toolbar and then choosing "Settings" and clicking on "Control Panel." Find "Add/Remove Programs" in the list and double click on it. Click on "Accessories" on the submenu and then choose "Communications." If HyperTerminal is installed you will see it listed on the "Communications" menu and you can simply click on it to start the program. If HyperTerminal is installed on your computer operating system you can activate it by clicking Start on your main toolbar and choosing "Programs" from the menu. If your computer has recently been upgraded then you may not have HyperTerminal. If your computer has WinMe already installed than the HyperTerminal program should be activated. #Hyperterm application windowsHyperTerminal is part of the Windows Me which is shipped by Microsoft. It is also capable of repairing any security flaws in HyperTerminal as well as some other problems that are known to Microsoft. #Hyperterm application for free
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |